|
|
|
Alternate Mounting
for Runtal Radiators
KR10
Floor
Post |
Attachment Bolt &
Nut (by others) |
|
The KR10 Floor Post is typically used to mount R
or RF radiators. Also, R2F and R3F radiators
over 4 tubes tall must also be mounted on KR10
Floor Posts. The K11 (R) or K12 (RF, R2F, R3F)
wall mounting brackets supplied with the
radiator are bolted to the floor post, using
nuts and bolts supplied by the installer. The
K45 offset bolt screws into the radiator, and
rests against the floor post to level the
radiator.
The 3 x 3 base has four mounting holes. The
installer supplies the appropriate mounting
bolts to secure the KR10 base to the floor.
The KR10s height is fixed to provide 3
clearance under the radiator, unless otherwise
specified. |
|
|
KR20 Pedestal |
 |
The KR20 Pedestal is used to mount R2F or R3F
radiators, up to four tubes tall. Radiators
over four tubes tall should not be mounted on
KR20 Pedestals, because they will be unstable.
Mounting is accomplished by setting the radiator
down over the fingers of the KR20. The bottom
tubes of the radiator rest on the pedestal,
while the fingers protrude up through the fins
to stabilize the radiator.
Option #48 (no wall mounting clips or straps)
should be ordered for radiators to be mounted on
KR20 Pedestals. The 3 x 3 base has four
mounting holes. The installer supplies the
appropriate mounting bolts to secure the KR20
base to the floor.
The KR20s height is fixed to provide 3
clearance under the radiator, unless otherwise
specified. |
|
|
KR30 Cantilever Bracket |
 |
The KR30 Cantilever Bracket is used to mount R2F
or R3F radiators, up to four tubes tall.
Radiators over four tubes tall should not be
mounted on KR30 Brackets, because they will be
unstable. Mounting is accomplished by
setting the radiator down over the fingers of
the KR30. The bottom tubes of the radiator rest
on the flat of the KR30, while the fingers
protrude up through the fins to stabilize the
radiator.
Option # 48 (no wall mounting clips or straps)
should be ordered for radiators to be mounted on
KR20 Pedestals. The KR30 Bracket is typically
used to mount the R2F or R3F radiators from
window mullions, where pedestal mounting is not
desired. The installer supplies the appropriate
mounting bolts to secure the KR30. |
|
|
KR4 Pedestal |
 |
The KR4 Pedestal is used to floor mount the RS2
and custom R column radiators. The pedestal is
welded to the radiators tubes at the same
intervals as would be required for wall mounting
brackets. The standard clearance under the
radiator is 4, unless otherwise specified.
The pedestal base is 5-1/2 x 3-3/4, and
includes two mounting slots. The installer
supplies the appropriate mounting bolts to
secure the KR4 Pedestals to the floor. |
|
|
